ADR® III (Monochromatic) Technical Training

Class Location:

• Customer Site

Class Description:

• Familiarization of all sub-systems including conveying, pneumatic, water, lighting, electronics, vibratory, belting, bed shift, vision (cameras), cutterwheels and operator interface. Operational set-up of sorting parameters and guidelines on optimal settings are explained. Troubleshooting, daily log sheets, preventive maintenance, maintenance schedules and system sanitation are also covered.

Class Duration:

• 2 days

Class Outline:

1) Orientation
2) System Overview (Operators, Maintenance, Supervisors)a) Infeed conveyor
b) Belt conveyor
c) Alignment fingers
d) Brushes
e) Bed shift
f) Lighting system
g) Sensors (cameras)
h) Cutterwheels
i) Size graderj) Control cabinet
k) Power cabinet3) Definitions of Technical Terms (Operators, Maintenance, Supervisors)a) Line-of-sight
b) Pixel
c) Sprite
d) Delay
e) Duration
f) Sensitivity
g) Size
h) Computer grid
i) Index signals4) Operation (Operators, Maintenance, Supervisors)
a) Control cabinet switches
b) Touchscreen controlsc) Starting and stopping
d) E-stop switches and resetting
e) Test cutting
f) Clean-in-place (CIP) systemg) Error messages
h) System sanitation
i) Shutdown procedure5) Theory of Operation (Maintenance)a) Introduction
b) MSDA
c) Terminator board
d) Dual learn board
e) Count board
f) Add board
g) Field board
h) Sync boardi) 68000 CPU board
j) Input/Output boards6) Maintenance (Maintenance)
a) Ballast setupb) MSDA alignmentc) Oscilloscope test points and connection points
d) Learning light
e) Learning lanes
f) Delay adjustment
g) Duration adjustment
h) Cutterwheel testing7) Scheduled Items (Operators, Maintenance, Supervisors)a) Daily checksb) Shift sanitation procedures
c) Cold start start-up
d) Maintenance schedulee) Short-term storage
f) Long-term storage